1 4 8 1 5 8 COMPAQ NO MORE PRODUCED Native| Translation ------+-----+-----+----- Form 3.5"/SLIMLINE Cylinders 2243| | | Capacity form/unform 545/ MB Heads 6| | | Seek time / track 10.0/ 2.0 ms Sector/track | | | Controller SCSI2 SI/FAST Precompensation Cache/Buffer 256 KB Landing Zone Data transfer rate 1.250 MB/S int Bytes/Sector 512 10.000 MB/S ext SYNC Recording method RLL 1/7 operating | non-operating -------------+-------------- Supply voltage 5/12 V Temperature *C 5 55 | -40 60 Power: sleep W Humidity % 5 95 | 5 95 standby W Altitude km -0.061 3.048| -0.061 12.192 idle 5.2 W Shock g 5 | 75 seek 9.0 W Rotation RPM 5400 read/write 6.5 W Acoustic dBA 40 spin-up W ECC Bit MTBF h 250000 Warranty Month 24 Lift/Lock/Park YES Certificates ********************************************************************** L A Y O U T ********************************************************************** CONNER CP30540 AEGEAN SCSI CUSTOMER OPTIONS +---------------------------------------------------------+ | |XX J2 | +-+ |XX | | |J1 |XX | | |HDA |XX I | | | TERMPWR|XX N | +-+ ++ |XX T | ++ |XX E | |XX R | |XX F |J3 |XX A |+-+Spindle Sync |XX C ||x|LED Drive E1++++++E5 |XX E ||x| ++++++ |X1 |+-+ | 1 |+-+0E1 |XX J4 ||x| | |XX Power |+-+0E5 (Alternate LED Drive) | +---------------------------------------------------------+ ********************************************************************** J U M P E R S ********************************************************************** CONNER CP30540 AEGEAN SCSI CUSTOMER OPTIONS Jumper Setting ============== E1/0E1-E3/0E3 SCSI ID --------------------- +----------+-----------------------+ | SCSI ID | Jumpers | | | E3/0E3| E2/0E2| E1/0E1| +----------+-------+-------+-------+ | 0 | OPEN | OPEN | OPEN | | 1 | OPEN | OPEN | CLOSED| | 2 | OPEN | CLOSED| OPEN | | 3 | OPEN | CLOSED| CLOSED| | 4 | CLOSED| OPEN | OPEN | | 5 | CLOSED| OPEN | CLOSED| | 6 | CLOSED| CLOSED| OPEN | | 7 | CLOSED| CLOSED| CLOSED| +----------+-------+-------+-------+ There are three jumpers available for configuration of SCSI ID: E1, E2, and E3. Use either but not both: E1 to E3 OR 0E1 to 0E3. The 0E header is not installed on drive configurations with a LED on the PCBA. Delay Spin: A jumper in the E4 location, disables spin up on power- on. Disabling spin up on application of power can also be enabled by setting the DSPN bit in MODE SELECT page 0. E4 Disable Spin on Power on E5/0E5 Terminators on TERMPWR Output Enable