P A L L A D I U M P 1 0 0 0 - 2 A F JTS CORP. Native| Translation ------+-----+-----+----- Form 3.5"/SUPERSLIMLINE Cylinders 4629| 1942| | Capacity form/unform 1000/ MB Heads 4| 16| | Seek time / track 15.0/ ms Sector/track | 63| | Controller IDE / ATA2 FAST/ENHA Precompensation Cache/Buffer 32 KB Landing Zone Data transfer rate MB/S int Bytes/Sector 512 16.600 MB/S ext Recording method RLL 1/7 operating | non-operating -------------+-------------- Supply voltage 5/12 V Temperature *C 5 55 | -40 70 Power: sleep 0.6 W Humidity % 5 90 | 5 90 standby 0.7 W Altitude km | idle 2.6 W Shock g 10 | 100 seek W Rotation RPM 4103 read/write 4.2 W Acoustic dBA 39 spin-up W ECC Bit MTBF h 250000 Warranty Month Lift/Lock/Park YES Certificates ********************************************************************** L A Y O U T ********************************************************************** JTS PALLADIUM P1000/1200-2AF INSTALLATION GUIDE P/N 88098-001 +---------------------------------------------------------+ | |XX | |XXI | |XXN | |XXT | |XXE | |XXR | |XXF | |XXA | |XXC | |XXE | |XX | | | |XX Power | |XX | | | |+-+ | || |JP1 +---------------------------------------------------------++-+ ********************************************************************** J U M P E R S ********************************************************************** JTS PALLADIUM P1000/1200-2AF INSTALLATION GUIDE P/N 88098-001 Jumper Setting ============== JP1 +8-----2+ +-POWER-++---IDE----- |o o o o| |O O O O||oooooooooooo |o o o o| |+12 +5||1oooooooooooo +7-----1+ \-------/+-------------- Master (Default) ----------------- o o x o When installing only one drive, leave the jumper o o X o in this factory set position. You can also use this setting for the first (Master) drive, when attaching a second (Slave) drive that conforms ATA-2 specifications. Master with Slave ----------------- o x o o Use this jumper setting for the first (Master) o X o o drive, in two drive installations where the second (Slave) drive does NOT conform to ATA-2 (EIDE) specifications. Slave ----- o o o x Use this jumper setting for the setting for the o o o X second drive of a two drive installation. Only one of the two drives attached can have this setting. Cable Select ------------ o o o o When using this jumper setting, the cable select o o xxx line (pin 28) determines the assignment of Master and Slave in two drive installations. Verify that you have the necessary signal cable modifications before using this jumper setting. If the select line in your cable is not modified, use the appropriate jumper settings for Master and Slave above. The first drive attached to a host adapter must be a Master. ********************************************************************** I N S T A L L ********************************************************************** JTS PALLADIUM JUMPER SETTING Notes on installation ===================== Installation direction ---------------------- horizontally vertically +-----------------+ +--+ +--+ | | | +-----+ +-----+ | | | | | | | | | +-+-----------------+-+ | | | | | | +---------------------+ | | | | | | | | | | | | | | | | | | +---------------------+ | +-----+ +-----+ | +-+-----------------+-+ +--+ +--+ | | | | +-----------------+ The drive will operate in all axis (6 directions).