M H D - 2 0 3 2 A T H O R N E T 9 FUJITSU Native| Translation ------+-----+-----+----- Form 2.5"/SUPERSLIMLINE Cylinders 7317| | | Capacity form/unform 3250/ MB Heads 4| | | Seek time / track 13.0/ 2.5 ms Sector/track | | | Controller IDE / ATA3 ULTRA Precompensation Cache/Buffer 512 KB Landing Zone Data transfer rate MB/S int Bytes/Sector 512 33.300 MB/S ext UDM33 Recording method EPR4ML operating | non-operating -------------+-------------- Supply voltage 5 V Temperature *C 5 55 | -40 65 Power: sleep 0.1 W Humidity % 8 90 | 5 95 standby 0.4 W Altitude km -0.300 3.000| -0.300 12.000 idle 0.9 W Shock g 100 | 500 seek 2.4 W Rotation RPM 4000 read/write W Acoustic dBA spin-up W ECC Bit SMART MTBF h 300000 Warranty Month Lift/Lock/Park YES Certificates ********************************************************************** L A Y O U T ********************************************************************** FUJITSU MHD-2021/2032AT/MHC2040AT JUMPER SETTING +-------------------------------------------------------------+ | | | | | +-----------------------------------------------C-A-+ | | | * * * * * * * * * * * * * * * * * * * * * 1 * * | | | | * * * * * * * * * * * * * * * * * * * * * * * | | +----+----------------------------------------------SWITCH----+ D B ********************************************************************** J U M P E R S ********************************************************************** FUJITSU MHD-2021AT/2032AT/MHC2040AT JUMPER SETTING Jumper Setting ============== +-------------------------------------------------------------+ | | | | | +---------------------------------------------------+ | | | * * * * * * * * * * * * * * * * * * * * * 1 * * | | | | * * * * * * * * * * * * * * * * * * * * * * * | | +----+----------------------------------------------SWITCH----+ Factory Default --------------- --------C-A-+ * * * | OPEN * * * * | ------D-B-+ MASTER-device * * * | * * * * | ----------+ Master drive (device #0) or slave (device #1) is SLAVE-device+ selected. * * * | * * xxx | Note: ----------+ Pins A and C should be open. -CSEL-------+ * xxx |CSEL signal is enabled. * * * * | ----------+ NOTE The CSEL setting is not depended on setting between pins B and D. By connecting the CSEL of the master device to the CSEL Line (conductor) of the cable and connecting it to ground further, the CSEL is set to low level. The device is identified as a master device. At this time, the CSEL of the slave device does not have a conductor. Thus, since the slave device is not connected to the CSEL conductor, the CSEL is set to high level. The device is identified as a slave device. ********************************************************************** I N S T A L L ********************************************************************** -ANY DIREC. Notes on installation ===================== Installation direction ---------------------- horizontally vertically +-----------------+ +--+ +--+ | | | +-----+ +-----+ | | | | | | | | | +-+-----------------+-+ | | | | | | +---------------------+ | | | | | | | | | | | | | | | | | | +---------------------+ | +-----+ +-----+ | +-+-----------------+-+ +--+ +--+ | | | | +-----------------+ The drive will operate in all axis (6 directions).